chat now
|
| Place of Origin: | China |
| Brand Name: | JWSY |
| Model Number: | ITS-AX2-2 |
The barrier gate anti smashing radar is developed to meet the management application requirements of entrances and exits such as parking lots and underground garages. By working in conjunction with the gate main control board, it can achieve precise control of the gate rod lifting and lowering, while effectively avoiding the gate rod from "accidentally injuring" targets passing through the radar field of view, achieving intelligent anti smashing.
The radar adopts a highly integrated RF chip SoC solution, which has the characteristics of small size, low cost, all-weather operation, high detection sensitivity, high accuracy, simple debugging and installation, stability and reliability.
The working frequency of this radar is 79GHz, using linear frequency modulation continuous waveform, with a usable bandwidth of up to 4GHz, a distance resolution of 4cm, and a ranging accuracy of better than 2cm. The millimeter wave antenna adopts multiple transmission and reception methods, with high angular resolution and angle measurement accuracy; The signal processing and control unit adopts a dual core architecture of DSP and ARM. Through the joint optimization design of software and hardware, this product can accurately identify and distinguish pedestrians, vehicles, and other targets passing through the gate area, avoiding phenomena such as "smashing cars", "smashing people", and "not falling the gate".
▋Technical Specifications
| Product Name | Barrier anti smashing radar |
| Product Model | ITS-AX2-2 |
| Working Voltage | (Typical value 12V/1A) |
| Operating Temperature | -40℃~85℃ |
| average power consumption | < 2.5W |
| waterproof rating | IP66 |
| communication interface | RS485； Bluetooth |
| housing dimensions | 107.9*73.6*17.2mm |
| Factory horizontal width | Default ± 0.5 meters, can be customized within ± 1.5 meters according to actual conditions. |
| Factory longitudinal length | 1-6m configurable, default 3m |
| Online debugging | 485； Bluetooth communication debugging |
| Online upgrade | 485； Bluetooth communication upgrade |
| Applicable Type | Straight poles, fences, billboards, airborne barriers, etc |
▋Product Features
▋Product precautions
5) It is not recommended to use radar in single channel mixed in and out scenarios with installed fences and billboard poles.
6) For scenarios where there is a gap of more than 1 meter between the body of semi trailers, cement tankers, and other vehicles entering and exiting, it is recommended to use a dual radar installation scheme or remotely control the brake lever.
7) This product is not recommended to be deployed on muddy roads. Extreme weather (rainstorm, heavy snow) may affect the stability of radar performance.
8) Normally, the detection distance should be set according to the length of the pole. The detection distance should be slightly less than or equal to the pole length to prevent personnel or objects from passing outside the gate pole and being detected by the radar.
9) When learning to record the environment, the straight pole may shake when it falls to the ground. Wait until the pole is completely stable before proceeding with subsequent operations.
10) If there are bullet bars caused by radar, please relearn the background.
11) When metal strong scattering objects such as speed bumps (such as iron plates) are located directly in front of the radar, the radar installation height is 750-800mm.
12) If there are special environments that require the installation of radar, please contact our company first and then install it correctly according to the recommendations.
english
français
Deutsch
Italiano
Русский
Español
português
Nederlandse
ελληνικά
日本語
한국
polski
فارسی
বাংলা
ไทย
tiếng Việt
العربية
हिन्दी
Türkçe
indonesia
